11
Chapter 2: Basic Operation
2.5 Display and Keypad Illumination
• Press for 1 second, from any mode, to enter illumination
adjustment mode and turn the lights on.
LAMP
DXXXX-1
LAMP
LAMP LAMP
LAMP
STBY
• Subsequent presses of the key cycles the possible illumination
settings: L3, L2, L1, OFF, L1, L2, L3 etc. where L3 is the brightest
setting.
The display times out to normal operation after 7 seconds of keypad
inactivity.
Pressing any other key before the 7 second time-out will select the
mode assigned to that key (for example, AUTO selects Auto mode,
STANDBY selects Standby mode).
Notes: If other SeaTalk instruments or autopilot control units are connected
to SeaTalk, the illumination can be adjusted from these units.
Any adjustments to the illumination are lost when the unit is
switched off.
The keys are still lit at a courtesy level when the display lighting is off.
If the illumination is initially OFF, upon entry to illumination adjustment
mode the illumination is set to level 3.
To Next Page
Loading...
