56
ST600R Autopilot Control Unit
ST6000 & ST7000 Autopilot Connections
ST6000 ST7000
Course Computer
Screen
(SeaTalk ground)
Red
(+12v)
Yellow
(SeaTalk Data)
Pin
Identification
Stripes
Note: The hand held socket can be installed anywhere on the SeaTalk bus.
6.3 Mounting the Bulkhead Socket
1. Apply the template to the bulkhead as required.
2. Drill the 18mm (45/64in) clearance hole and the two 2.4mm
(3/32in) pilot holes.
3. Remove the template.
4. Fit the plug cap (1) to the socket body (2) as shown.
5. Cut and strip the SeaTalk cable (not supplied - refer to table).
6. Pass the cables through the bulkhead and wire to the socket, making
sure the wires are connected to the correct pins.
To Next Page
Loading...
