26 ST600R Autopilot Control Unit
Changing the Rudder Gain
Press the +1 and -1 keys together for 1 second to display the Rudder
Gain screen, and adjust the setting in the same way as for the
response level. Refer to Chapter 7, “Post Installation Procedures”,
for instructions on how to check that the rudder gain is set correctly.
Warning: It is important that the rudder gain is correctly set on planing
craft. Incorrect adjustment will lead to poor steering
performance and is dangerous at high speeds.
3.4 Alarms
This section summarises the alarms (in order of priority) that are
reported by the ST600R.
Press STANDBY to clear an alarm and return to hand steering,
unless indicated otherwise.
ST
FAIL
NO
LINK
AUTO
RELSE
OFF
CRS
NO
DATA
DRIVE
STOP
LARGE
XTE
WIND
SHFT
NEXT LOW
BATT
WATCH WATCH
To Next Page
Loading...
