Raymarine ST600R - Auto Tack; Wind Trim; Auto Release; Response

49
Chapter 5: Customising the System
Auto Tack*
The AutoTack angle is the angle through which the vessel will turn
when the automatic tack feature is selected. The value must be within
the range 40 ~ 125° and can be adjusted in 1° steps.
Wind Trim*
This varies the response of the autopilot when in wind mode.
The settings available are as follows:
Range: 1 Normal setting
2 Faster response for wind shifts
Default: 1
Auto Release
Auto Release provides emergency manual override, should it be
necessary, to avoid an obstacle at the last moment. This option only
applies to sterndrive actuators – for all other systems this option
should be set to off.
Range: Off
On
Defaults: 0 for Displacement, Semi-displacement &
Planing
1 for Sterndrives
Response
This is the power-on response setting. The response level can be
changed during normal operation (see Section 3.3) or via the
Response Data Page, if this is set for display (see Section 2.6).
Range: Level 1 (Auto Seastate)
Level 2 (Auto sea state inhibit)
Level 3 (Auto sea state inhibit counter rudder)
Default: Level 1
*Not available on th ST4000 Plus and ST5000 Plus