34 ST600R Autopilot Control Unit
To enter your chosen code number on the ST600R control unit, use
the keys as shown.
--1
--10
stdby
+1
+10
auto
track
Increase the number at the flashing cursor:
Decrease the number at the flashing cursor:
Move the cursor to the next position
CodeLock Manual
CODE
CODE
0345
Press this key to accept code, after the
last number has been entered, and go
to normal operation
0 1 2 3 4 5 6 7 8 9
0 9 8 7 6 5 4 3 2 1
STBY
Code Complete Normal Operation
To enter the code on any other master display unit, refer to the
handbook for that unit for details of the code entry procedure.
4.4 Code Number Problems
• If an incorrect code number has been entered, the four dashes are
redisplayed, with the prompt “code”. Repeat the procedures
illustrated above entering the correct four digit number.
• If you forget your code number, you must take your master unit to an
authorised dealer, together with appropriate proof of ownership such
as the original invoice. The dealer will be able to reset the unit so
that you can enter a new code.
To Next Page
Loading...
