Raymarine ST600R - Rudder Gain

32 ST600R Autopilot Control Unit
Initial Setup
When you first install your ST600R, CodeLock is set OFF. To
activate CodeLock, refer to the following flow diagram.
--1
stdby
Setting CodeLock
VERS
ION
CODE
0345
CODE
AUTO
STBY
STBY
CODE
MAN
CODE
SET
--1
--10
stdby
+1
+10
auto
track
+1
Enter a number at the flashing cursor:
Move the cursor to the next position
+1 cycles: 0 1 2 3 4 5 6 7 8 9
-1 cycles: 0 9 8 7 6 5 4 3 2 1
Normal Operation
Enter a Four Digit Code Number
Software Version CodeLock Screen
Code Complete Auto Mode or...
Code Set Normal Operation
Manual Mode
Software Version
stdby
OR
4
9 10
• Make sure that the autopilot is in Standby mode before accessing
Intermediate Setup.
• If the CAL LOCK screen is displayed instead of the VERSION
screen, you need to turn off the lock feature in Dealer Setup.
The Intermediate Setup displays have the following functions: