58
ST600R Autopilot Control Unit
6.4 Bulkhead Bracket Installation
The hand held remote is supplied with a stowage bracket. This
bracket should be attached to a convenient bulkhead using the screws
provided.
6.5 Functional Test (Repeater Unit)
If you have installed your ST600R as an autopilot repeater, you
should perform the functional test described in this section. However,
if you have installed the ST600R as the only control unit for a Type
100/300 course computer, go to Chapter 7, “Post Installation
Procedures”, and follow the instructions.
To Next Page
Loading...
