52
ST600R Autopilot Control Unit
This chapter describes the following:
•Planning the installation, including choosing the connection cable
•Determining the connections for your autopilot
•Mounting the bulkhead socket
•Installing the bulkhead bracket
6.1 Planning the Installation
This chapter explains how to install the ST600R autopilot control
unit. Before you start, obtain the correct connection cable, and decide
how you will site the unit and run the cables.
Choosing the Correct Connection Cable
Because the range of Raymarine autopilots is extensive, the cable
used to connect the ST600R must be ordered separately (see below).
Part Number Cable Description
D131 Round connectors at both ends, 9m (29ft. 3in.)
D177 No plugs but fitted with an in-line 5A fuse,
3m (9ft. 9in.)
D229 Flat moulded plug with bare ends, 3m (9ft. 9in.)
D284 Flat moulded plugs at both ends, 1m (3ft. 3in)
D285 Flat moulded plugs at both ends, 3m (9ft. 9in.)
D286 Flat moulded plugs at both ends, 6m (19ft. 6in.)
D287 Flat moulded plugs at both ends, 9m (29ft. 3in.)
Q018 SeaTalk cable (no plugs) sold by the 0.3m (1ft)
Cabling Guidelines
• Avoid running cables through bilges where possible
• Secure coiled lengths at regular intervals
• Avoid running cables close to fluorescent lights, engines, radio
transmitting equipment etc
To Next Page
Loading...
