Servicing and maintenance 6
BAL_K21_EN_3V3_BLA_121-006423019 35 / 44
Visual inspection of the instructions
and labeling (buttons / switches)
– Verify that all labels are present
and legible.
– All labels must be present, legible
and firmly applied.
Visual inspection of the glass label – Verify that the label is present. – The glass label must be firmly at-
tached at eye level.
6.3 Cleaning and care
DANGER
Warning: risk of fatal electric shock!
a) Risk of death by electrocution
ð Do not touch the drive system while the main power is connected.
ð Do not spray water into the drive system.
NOTICE
Before cleaning, select MANUAL mode and also press the emergency stop button. Rinse
cleaned surfaces with a clean, damp cloth.
IMPORTANT
Keep the system clean from dirt, leaves, snow and ice!
a) If heavily soiled, please contact a professional.
b) Do not use road salt or gravel in front of the entrance area or within the system.
c) We recommend that you impregnate the safety strips with water repellent care products.
IMPORTANT
Any other cleaning products, not mentioned here, should not be used!
What Interval Cleaning agent
General parts Weekly Damp cloth, neutral to low alkaline,
wetting agent solution / vinegar di-
luted with water
Sensors / safety strips Weekly Synthetic cleaner
Floor mats Weekly Vacuum cleaner / carpet cleaner
Display cases Weekly Commercial glass cleaner
To Next Page
Loading...
