Redline Connect Series - Site Survey; General Information; Network Settings; Table 14: Site Survey - General Information Settings

CONNECT-OWS Installation Guidelines
70-00200-02-00 Proprietary Redline Communications © 2014 Page 26 of 70 December 3, 2014
3 Site Survey
It is recommended to perform a site survey before installing the Connect-OWS system.
The data accumulated during this process is necessary to understand the operating
characteristics and obtain the best performance from the wireless system.
3.1 General Information
The General Information fields uniquely identify each installed system. It is
recommended to record this information prior to installation.
Table 14: Site Survey - General Information Settings
Setting
Serial Gateway
Radio Management
Name
Details
Location
Contact
3.2 Network Settings
The Connect-OWS must be assigned two unique IP addresses before it is connected to
the base station and the local area network (LAN). When DHCP is enabled, the
remaining settings are populated automatically by the DHCP server.
Table 15: Site Survey - Network & Syslog Server Settings
Setting
Serial Gateway
Radio Management
Network
DHCP Enable
IP Address
Subnet Mask
IP Gateway Address
DNS Server 1
DNS Server 2
Syslog Settings
Enable Syslog
Server IP
Chapter 3