CONNECT-OWS Installation Guidelines
70-00200-02-00 Proprietary Redline Communications © 2014 Page 58 of 70 December 3, 2014
4.4.4 Radio Management Settings
Click Radio Configuration->Radio Management to configure the wireless interface
settings. This screen will display basic information about the wireless interface. To
configure the wireless interface, click the Direct Radio management button to launch a
new browser window with the standard interface configuration screen used for all RDL-
3000 wireless terminals. The operator must login to the radio management interface.
Install Options Key Upgrade (Optional)
The wireless terminal default options key is installed at the factory. This procedure is
required only if additional features have been purchased (e.g., higher wireless
throughput).
1. Use a Web browser to login to the wireless terminal. You must login as administrator.
2. Click Utilities -> Product Options to display the Product Options screen.
3. Enter a valid permanent or temporary options key in unused Options Key field.
Important: Do not overwrite the default key from the factory.
4. Set the Active Options Key setting to the new key (e.g., Options Key 2).
5. Click Activate to enable the new features. It is recommended to reboot the system.
Figure 48: Configuration: Product Options Screen
Note: The options key may also be installed using Telnet. Refer to the RDL-3000 Family
User Manual the required commands.
Network and RF Settings
4.5 Review and adjust the radio management parameters as
required. Refer to the information collected during the site
survey (3.1 General Information
The General Information fields uniquely identify each installed system. It is
recommended to record this information prior to installation.
Table 14: Site Survey - General Information Settings
To Next Page
Loading...