Redline Connect Series - Network Settings

CONNECT-OWS Installation Guidelines
70-00200-02-00 Proprietary Redline Communications © 2014 Page 59 of 70 December 3, 2014
Contact
4.6 Network Settings
The Connect-OWS must be assigned two unique IP addresses before it is connected to
the base station and the local area network (LAN). When DHCP is enabled, the
remaining settings are populated automatically by the DHCP server.
Table 15: Site Survey - Network & Syslog Server Settings
Setting
Serial Gateway
Radio Management
Network
DHCP Enable
IP Address
Subnet Mask
IP Gateway Address
DNS Server 1
DNS Server 2
Syslog Settings
Enable Syslog
Server IP