CONNECT-OWS Installation Guidelines
70-00200-02-00 Proprietary Redline Communications © 2014 Page 53 of 70 December 3, 2014
4.4 Configure Connect-OWS System
All configuration is performed using the Connect-OWS web interface. Use the following
steps to configure the Connect-OWS serial ports and setup a link to the base station:
1. Connect an Ethernet cable from the test PC to Connect-OWS port ETH 1 or ETH 2.
2. Power-on the Connect-OWS.
3. Open a Web browser and login to the Connect-OWS management interface.
4. Configure the network, serial ports and wireless settings.
Figure 42: Configuration: Connect-OWS System Configuration Block Diagram
4.4.1 Required Materials
Configuration of the Connect system settings requires additional equipment and
materials supplied by the installer. The following list is a guideline only, and additional
materials may be required based on local conditions at each installation site.
Table 24: Installation: Installer Supplied Materials
Portable computer with Web browser.
A CAT-5e crossover cable terminated with RJ-45 at both ends.
To Next Page
Loading...