7.13.3 To remove and install the lower vibration
damping unit
1. Remove the frame. Refer to
To remove and install
the frame on page 34
.
2. Remove the 3 screws and the cover of the vibration
damping unit (A).
3. Remove the vibration damping unit (B).
4. Install in the opposite sequence.
7.13.4 To remove the fan guard
1. Remove the frame. Refer to
To remove and install
the frame on page 34
.
2. Pull out the center part of the 4 clips.
3. Remove the 4 clips from the frame.
4. Remove the fan guard.
5. Install in the opposite sequence.
7.13.5 To replace the harness
WARNING: A damaged harness can make the
product fall and cause injuries. Make sure to
install the clamp correctly.
1. Stop the engine.
2. Remove the clamp from the strap.
3. Push the end of the strap through the eyelet.
4. Pull the new strap through the eyelet.
5. Put the pin into the strap to attach the clamp to the
new strap.
36 - Repair instructions 1662 - 003 - 04.11.2021
To Next Page
Loading...
