l. When pressing the emergency stop button or switching from another state to the automatic state, it needs
to return to the reference (the bending arm returns to the origin).
Note: When a failure occurs during automatic operation and the structure cannot be returned to the initial
position of work, press the emergency stop and reset it in the manual gear to return to the reference.
(6) Parameter setting
1) When performing a new production task, mechanical adjustment is required, which may produce several
unqualified samples. Please make a single-step adjustment when debugging.
2) Please select the appropriate mold after changing the diameter of the steel bar. There are two standard
molds for this model, the specific parameters are as follows:
Click the icon，
3) The mold parameters have been preset before leaving the factory, please do not adjust
for hooks， for stirrups
Please confirm whether the mold is correct when making steel bars!
Note: The steel bars of the same batch and the same diameter cannot be changed at will! Otherwise,
the angle will be inaccurate!
4) The angle adjustment corresponds to the diameter of the steel bar
When working, the speed will have some influence on the length and angle. Please fine-tune the length and
To Next Page
Loading...