angle of the machine after the speed is fixed.
5) The internal programs and key parameters of the servo drive, touch screen and PLC have been set before
leaving the factory, and we need to designate professional and technical personnel to modify the operation,
and other personnel are not allowed to modify it privately!
6) Speed setting
7) Note: When processing ￠12 round steel or rebar, the processing speed should be limited, otherwise the
machine will be seriously damaged if the speed is too fast. When the size of the bending stirrup (side length
or diagonal side length) is greater than 400 mm, the bending speed should be slowed down accordingly.
These have been set in the program, but the customer should adjust it according to the actual situation.
8) Tail length compensation, demold length setting
5.1.2 Operation instructions of touch screen system
Language selection screen: (standard version in six languages)
The screen shown in the figure below is the main operating screen of the hoop bending machine touch
screen system:
OperationManualReflexFastFormGX616CNCRebarStirrupBendingMachine
To Next Page
Loading...