Description of the device
Variomat 1 — 06.07.2016 – Rev. B English —
The scope of delivery is described in the shipping document and the content is shown on the packaging. Immediately after receipt of the
goods, please check the shipment for completeness and damage. Please notify us immediately of any transport damage.
Basic pressurisation equipment:
• The device on a pallet.
– Control unit and "VG" primary tank.
– Primary tank with accessories are packed on the tank base.
• "VE" aeration and de-aeration
• "DV" degassing valve
• Reducing sleeve
• "LIS" pressure pick-up
– Plastic sleeve with operating manual.
Optional equipment and accessories
The following optional equipment and accessories are available for this device:
• Thermal insulation for the primary tank.
• Secondary tanks
– Accessories are provided as a package at the tank base
• "VE" aeration and de-aeration
• "DV" degassing valve
• Reducing sleeve
• Accessories with BOB pipe for "TAZ+" temperature limiter
• Fillset for make-up with water.
– Fillset with integrated back flow preventer, water meter, dirt trap, and locking mechanisms for the "WC" make-up line.
• Fillset Impulse with FQIRA+ contact water meter for make-up with water.
• Servitec for make-up and degassing.
• Fillsoft for softening the make-up water from the public water network.
– The Fillsoft is installed between the Fillset and the device. The device controller evaluates the make-up quantities and signals
the required replacement of the softening cartridges.
• Enhancements for the device controller:
– I/O module for standard communication.
– Communication module for external operation of the controller
– Master-Slave-Connect for master controllers for maximum 10 devices.
– Combined switching to increase capacity and parallel switching of 2 hydraulically directly connected systems
– Bus modules:
• Lonworks Digital
• Lonworks
• Profibus DP
• Ethernet
• Diaphragm rupture monitor.
Note!
Separate operating instructions are supplied with accessories.
To Next Page
Loading...
Need help?
General
