lation
— English Variomat 1 — 06.07.2016 – Rev. B
Connection to the facility system
Hot water vapour can cause burns to skin and eyes.
Hot steam can escape from the safety valve. The hot steam will cause scalding of the skin and eyes.
• Ensure that the blow-off line of the safety valve is routed so that injuries are not possible.
Damage due to improper installation
Additional device stresses may arise due to the connection of pipes or system equipment.
• Ensure that pipes are connected from the device to the system without stresses being induced.
• If necessary, provide support structures for the pipes or equipment.
Connection to the primary tank
The control unit is positioned to the primary tank as determined by the selected installation variant, and is connected to the tank using
its connection set, see chapter 6.3.3 "Tank installation" on page 20 .
The connections to the system are identified by adhesive labels on the control unit:
Überströmung Nachspeisung
nlage Zur Anlage Zum Behälter
Pump to system connection
Overflow valve to system
connection
Make-up to system connection
To Next Page
Loading...
