Reflex Variomat VS 1 - Tank Add-on Component Installation

Installation
Variomat 1 — 06.07.2016 – Rev. B English —
19
6.3.2
Installation of add-on components for the tanks
The add
-on components are packed in plastic bags and
attached to the base of the devices.
•
Pressure compensation elbow (1).
•
Reflex Exvoid with pre-fitted check valve (2)
•
"LIS" pressure pick-up
For add
-on components, proceed as follows:
1
. Install the Reflex Exvoid (2) at the connection of the
corresponding tank.
2
. Remove the protective cap from the degassing
valve.
3
. Use the compression fitting to install the pressure
compensation elbow (1) for aeration and
ventilation at the tanks.
Note!
Install the "LIS" pressure pick
-up only after finalising the installation of the primary tank, see chapter 6.3.6 "Fitting the
level s
ensor" on page 26 .
Note!
To ensure fault
-free operation, do not seal off the aeration and ventilation.