What to do if there is water to pump but no output in my Regal 32 EXPRESS?
If there is water to the pump but no output in your Regal Boat, the fresh water pump or pressure switch may be faulty. Replace the fresh water pump or the pressure switch.
What causes the gauge to read erratically on my Regal Boat?
If the gauge reads erratically on your Regal Boat, it is likely due to a loose ground or hot wire. Repair or replace the wire and/or connection.
How to fix low water pressure in my Regal Boat?
If you're experiencing low water pressure in your Regal Boat, the fresh water pump may be defective. Consider replacing the water pump.
What causes vertical bars to flicker, jitter, or shimmer on the image of my Regal 32 EXPRESS Boat TV?
If vertical bars appear to flicker, jitter, or shimmer on the image of your Regal Boat TV, the coarse function may not be adjusted properly. Adjust the coarse function, then adjust the fine function.
What causes horizontal bars to flicker, jitter, or shimmer on the image of my Regal Boat TV?
If horizontal bars appear to flicker, jitter, or shimmer on the image of your Regal Boat TV, the fine function may not be adjusted properly. Adjust the fine function to the owner’s manual specifications.
Why does water continue dripping briefly into the bowl after the flush cycle is complete on my Regal Boat?
If water continues dripping briefly into the bowl after the flush cycle is complete on your Regal Boat, it is normal operation if only a small amount drips from the nozzle, especially if the toilet is installed below the waterline with a vacuum breaker in the water supply line.
How to troubleshoot inadequate AC power with gen-set running on my Regal 32 EXPRESS Boat?
If you're experiencing inadequate AC power with the generator set running on your Regal Boat, it could be that the electrical demand is greater than the electrical output. To resolve this, turn off appropriate equipment breakers to lessen the load.
What to do if there is no power to AC outlets and/or equipment in my Regal Boat?
If there is no power to AC outlets and/or equipment on your Regal Boat, first check if the main AC ship’s panel breakers are tripped or in the “off” position, and reset or activate them. Ensure the shore power cord is connected properly. Also, check if any GFCI outlets have tripped and reset them after identifying the cause of the trip.
Why is my Regal 32 EXPRESS Boat battery not charging when the engine is running?
If your Regal Boat's battery is not charging while the engine is running, check for a loose belt and tighten it. If the belt is fine, the alternator may be faulty, requiring repair or replacement. Another possible cause is a faulty voltmeter, which would need to be replaced.
What to do if my Regal 32 EXPRESS's 12 volt equipment is not working?
If the 12 volt equipment on your Regal Boat is not working, start by checking if the equipment switch is in the “off” position and switch it to the “on” position. Next, check for blown circuit breakers or fuses and reset the breakers or replace the fuses. Also, inspect the battery for weakness or being dead and replace it if necessary. Eliminate any corrosion from connections, tighten any loose wires, and if there's an internal short in the equipment, replace the faulty component.
Explains the meaning and importance of various safety labels.
Covers fundamental practices for safe operation on the water.
Lists essential safety gear mandated for boat operation.
Details the types and usage of fire extinguishers on board.
Describes signals used to indicate distress and request assistance.
Guidance on using marine radio for communication.
Information on the availability and use of life rafts.
Lists mandatory equipment required by the Coast Guard.
Discusses hazards related to exhaust fumes and carbon monoxide.
Addresses the dangers of alcohol consumption while boating.
Covers reporting and regulations for accidents.
Discusses how weather affects boating safety.
Details the specific rules for avoiding collisions and navigating safely.
Details the boat's fuel system components and specifications.
Covers the boat's electrical systems, including AC and DC power.
Guidance on the initial engine break-in period.
Describes the boat's gauges and instruments at the helm.
Procedures for safely starting and stopping the engines.
Pre-departure checks and procedures before setting sail.
Guidelines for starting and stopping engines safely.
Techniques and considerations for safely docking the vessel.
Guidance on responding to various emergency situations on board.
Operation and safety of the carbon monoxide detector.
Operation and maintenance of bilge pumps and float switches.
Details the automatic fire suppression system.
Function and purpose of the high water alarm.
Charts to help identify and resolve common problems.
Checklists for proper boat storage and winterization procedures.
General| Beam | 10 ft 4 in |
|---|---|
| Fuel Capacity | 129 gallons |
| Water Capacity | 30 gallons |
| Holding Tank Capacity | 28 gallons |
| Draft (Drive Down) | 36 in |
| Deadrise | 20 degrees |
| Draft | 36 in |
To Next Page
