39
Troubleshooting
MEASUREMENT
PRINTER
OTHER
MESSAGE/PROBLEM
Instrument continually aligns — does
not take reading.
Will not print.
Paper jams in printer.
No power.
Screen blank.
Clock/date incorrect.
Instrument “locks up.”
REMEDY
Reposition patient.
Position instrument away
from bright lights.
Out of paper.
Printer not turned on in
setup (see p. 35).
See instructions on inside of
printer door.
Check fuses and/or power
outlet.
Adjust contrast control.
Instrument in “sleep” mode
— push any gray button.
Check fuses.
Check power outlet.
Change settings in setup
(see p. 18).
Press red reset button.
(See p. 5, No. 13 for location.)
If problems still persist, contact your local authorized dealer or call our Customer Service Department at
(716) 686-4500.
NOTE: Circuit diagrams, component parts list descriptions and calibration instructions are available only to the ap-
propriately qualied personnel.
To Next Page
Loading...
