control instruments ................................................(current page)
clock ......................................................................(current page)
clock ......................................................................(current page)
CLOCK
The time is displayed when the ignition
is switched on.
Resetting the clock 1
– press button 2 for approximately
three seconds to enter time setting
mode;
– when the hour flashes, press
button 2 again to adjust it;
– wait approximately three seconds,
the minutes will flash; press button 2
to set the minutes;
– wait approximately three seconds,
the minutes will stop flashing; the
time is set.
If the electrical supply is cut (battery
disconnected, broken supply wire,
etc.), the clock will lose its time set-
ting.
The clock must be reset.
We recommend that you do not
adjust these settings while driving.
1
2
1
2