Renishaw OMP40-2 - Installing the Batteries

3.5
System installation
1
4
Installing the batteries
NOTES:
See Section 5, “Maintenance” for a list of suitable
battery types.
If dead batteries are inadvertently inserted, the
LEDs will remain a constant red.
Do not allow coolant or debris to enter the battery
compartment. When inserting batteries, check that
the battery polarity is correct.
After the batteries have been inserted, the LEDs
will display the current probe settings (for details,
see Section 4, “Trigger Logic™”).
Please remove the
battery isolation device
from the battery
compartment before use.
2
3