2
EC DECLARATION OF CONFORMITY
Renishaw plc declares that the product:
Name Description
OMP40 Optical machine probe
has been manufactured in conformity with the following standards:
BS EN 61326: 1998/ Electrical equipment for measurement,
A1:1998/A2:2001 control and laboratory use - EMC
requirements. Immunity to annex A
- industrial locations. Emissions to class A
(non-domestic) limits.
and that it complies with the requirements of the following
directives (as amended):
89/336/EEC Electromagnetic compatibility
The above information is summarised from the full EC Declaration
of Conformity. A copy is available from Renishaw on request.
FCC
Information to user (FCC Section 15.19)
This device complies with Part 15 of the FCC rules. Operation is
subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Information to user (FCC Section 15.105)
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in
a commercial environment. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used
in accordance with this installation guide, may cause harmful
interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which
case you will be required to correct the interference at your own
expense.
Information to user (FCC Section 15.21)
The user is cautioned that any changes or modifications not
expressly approved by Renishaw plc or authorised representative
could void the user’s authority to operate the equipment.
Preliminary information
To Next Page
Loading...
Need help?
General
