3
Safety
Only qualified persons should change the switch
settings or replace fuses.
Where appropriate, remove the mains supply from
units before removing covers.
Warranty
Equipment requiring attention under warranty
must be returned to your supplier. No claims will
be considered where Renishaw equipment has
been misused, or repairs or adjustments have
been attempted by unauthorised persons.
Changes to equipment
Renishaw reserves the right to change
specifications without notice.
CNC machine
CNC machine tools must always be operated
by competent persons in accordance with the
manufacturer’s instructions.
Care of the probe
Keep system components clean and treat the
probe as a precision tool.
Probe IP rating
IPX8
Related publications
When you install the OMP40 probe system,
you will also need to refer to one or more of the
publications listed below for details of how to
install the ancillary equipment.
• Optical module machine (OMM) installation
and user’s guide – Renishaw part No.
H-2000-5044.
• MI 12 interface unit installation and user’s
guide – Renishaw part No. H-2000-5073.
• Optical machine interface (OMI) installation
and user’s guide – Renishaw part No.
H-2000-5062.
• PSU3 power supply unit installation and
user’s guide – Renishaw part No.
H-2000-5057.
!
Preliminary information
To Next Page
Loading...
Need help?
General
