Renishaw PH10 - System Interconnection Diagrams

34
System interconnection diagrams
10 System interconnection diagrams
This section describes a number of PH10 system interconnections and recommends interconnection
cables and configuration switch settings.
The recommended configuration switch settings are given in a table below each interconnection diagram.
The tables do not include all the configuration switches. Where configuration switches are not specified for
the PHC10-2, please refer to sections 4 to 6. For other product configuration switch settings, please refer
to the appropriate installation guide.
The interconnection diagrams include:
• The PH10T or PH10M system with standard two-wire touch-trigger probes (see figure 22 and
table 21)
• The PH10M system with standard two-wire touch-trigger probes and autochange (see figure 23 and
table 22)
• The PH10M system with multiwired probes (see figure 24 and table 23)
• The PH10M system with multiwired probes and autochange (see figure 25 and table 24)
For further information on system interconnection, please contact your nearest Renishaw office.