Renkforce RF100 - 11. Installation

13
10. Before installation
• Removeallthecomponentscarefullyfromthepackaging.
• RemoveprotectionfoilsfromLCdisplay andthehousing.
• Cutthecabletiesoneachsidewiththesidecutter.
• Checkthatnopartsaremissingordamaged.Donotusethedeviceifanypartsaremissingordamaged.
11. Installation
a) Set up 3D printer
Whensettingupthe3Dprinter,observethatthepowerswitchmustbeeasytoreachsothatthedevicecan
beswitchedoffquicklyandeasilyincaseofmalfunction.
Ensureproperventilationwhensettingupthedevice.Donotputthedevicedownonsoftsupportssuch
asacarpetorbed,etc.theaircirculationalsomustnotbeimpairedbyotherobjects.Thispreventsheat
dissipationfromtheproductandmayleadtooverheating(dangerofre).
Makesurethatthedevicehasastablefootingandplaceitonastableunderground.Personsmaybe
injuredifthe3Dprinterdrops.
EnsurethatthepowerandUSBcablesareneitherpinchednordamagedbysharpedges.
Alwaysplacecablessothatnoonecantripoverthemorbecaughtinthem.Thereisadangerofinjury.
• Placethe3Dprinteronadry,at,non-vibration-sensitiveandstablesurface.
Thereareanti-slipfeetonthebottomofthedevice.Ifnecessary,placeaprotectivematunderneaththedevicein
ordertoprotectthesurfaceoftheworktop.
b) Installation and connection
The mains outlet must be located near to the device and be easily accessible, so that in case of an
error, the device can be quickly separated from the mains voltage.
Be careful when handling power cable and mains connections. Mains voltage may cause potentially
fatal electrical shock.
Before plugging in the mains plug, ensure that the device voltage indicated at the 3D printer
corresponds to the available mains voltage. Do not connect the device if the indication does not
correspond to the available mains voltage. Incorrect supply voltage may lead to irreparable damage
to the device and danger to the user.