Renkforce RF100 - Control Panel and SD Card Printing; 12. Control Panel; a) Initial Operation

15
12. Control panel
• The3Dprinterisoperatedbythecontrolknob.
• TheLCdisplayshowsthemenuoptionsandtheoperationstatusviaan<Infoscreen>.
a) Initial operation
Description Action
Navigateinthemenustructure
Rotatethecontrolknobanticlockwise/clockwise
Adjusttheparameter
Select/enterthemenu
PressthecontrolknobConrmamenuoption/parameter
Returntopreviousmenu
b) Menu options and functions
FollowingreferstothePrinterFirmwareV1.0andfunctionsmaychangewithupdatedversions.
Menu option Function
< Info screen >
<Infoscreen>isshownafterswitchingonthe3Dprinterandduringprinting.Fordetails,
refertosection„c)<Infoscreen>“onpage18.
<Main>menu(duringstandbymode)
< Info screen > Returnto<Infoscreen>.
< Prepare > Enterthe<Prepare>menu.
< Print from SD >
SDcardhasbeendetectedsucessfully.
Enterthe“SDCard“menu.
< No SD card > SDcardhasbeennotdetectedsucessfully.
< About > Enterthe<About>menutocheckinformationregardingthermwareversion.
<Prepare>menu(duringstandbymode)
< Main > Returnto<Main>menu.
<Autohome>
Thebuildbedmovestozero(z=0)alongthez-axisandthenozzletothehomeposition
(x,y)=(0,100).
< Level bed > Enter < Level bed > menu.