Renkforce RF100 - B) Set Up Filament

22
• Iftheprinterdoesnotprintproperlyafterthebuildbedcalibration,followingstepsareneeded:
7
8
9
• Firstselect<Autohome>in
<Prepare>menu,thenselect
< Disable steppers > to unlock
motor.
• Adjust a 5 mm distance between
nozzleandbuildbedbyturning
thethread(Z-axis)anticlockwise
byhand.
• Gently turn the thread (Z-axis)
clockwise ...
• ...untilthereisa“click“sound
attheupperleftpartofthebuild
bed.
• Calibratethebuildbed,by
repeatingstep1to6insection
“a)Calibratebuildbed“onpage
21.
b) Set up lament
1
2
3
• Putthelament onthe lament
spoolholder.
• Install lament tube into the
lamenttubeholder.
• Feed lament through lament
tube until approx. 5 cm are
visibleontheextruderend.