Renkforce RF100 - B) Pause Printing; C) Adjust Parameters During Printing; D) Stop Printing; E) Perform < Emergency Stop

26
b) Pause printing
Whileprintingispaused,thenozzlecontinuestoheat.Therefore,pausetheprintonlyforashortperiod,
otherwisethenozzlewilloverheatandmaybecomeclogged.
• Pressthecontrolknobtoleavethe<Infoscreen>andenterthe<Main>menu.
• Select<Pauseprint>topauseprinting.
• Tocontinueprinting,select<Resumeprint>.
c) Adjust parameters during printing
Recommended for advanced users only.
• Pressthecontrolknobtoleavethe<Infoscreen>andenterthe<Main>menu.
• Enter<Tune>menutoadjustprintspeed,nozzletemperature,fanspeedandextruderllamentfeedingspeed.
Printspeed:Observetheprintingandadjusttheprintspeed.Theprintspeedmayinuencetheprintquality
againstdifferentprintobjectanddifferentlamentforexampleiftheprintspeedistoohigh,theprinting
objectmaynotadheretothebuildbed.
Nozzle temperature: Do not keep nozzle temperature at 260 °C for more than 10 minutes. After 10
minutes,decreaseitto230°Candkeepitatthistemperatureforatleast10minutesbeforeincreasingit
again.Ifyouconsistentlyoperatethe3Dprinterattemperaturesover230°C,thelifetimeoftheextruder
willdrasticallybeshortened.
FanSpeed:Pleasepayattentionwhenfanspeedissetto0RPMduringnozzleheating,asthismaycause
cloggingofthenozzle.
Flow(extruderllamentfeedingspeed):Observetheprintingandadjustthespeed.Ifthespeedistoohigh,
thenozzlemaybecomeclogged.
d) Stop printing
• Pressthecontrolknobtoleavethe<Infoscreen>andenterthe<Main>menu.
• Select<Stopprint>tostopprinting.Itmaytakeseveralsecondsforthe3Dprintertostopcompletely.
• Thenozzlereturnstohomepositionandthebuildbedmovesdown.Nozzlestartscoolingdown.
e) Perform < Emergency stop >
• Select<EmergenceyStop>atthecontrolknobtoterminateanyrunningtasksimmediately.
Allaxismovementandextrusionoflamentwillbestopped.The3Dprinterdoesnotacceptanyinput,the<Info
screen>stopsupdating.
• Restartthe3Dprinter(fordetailsreferto“f)Restartthe3Dprinter“onpage27).