Renkforce RF100 - Page 17

17
Menu option Function
< MoveY>
SelectY-Axismovementandenterthe< MoveY>menutoadjusttheY-axismovement
intherange+100to0mm.
The extruder moves forwards/backwards along the Y axis (*backwards: toward to
control panel).
< MoveZ>
SelectZ-Axismovementandenterthe< MoveZ>menutoadjusttheZ-axismovement
intherange0to+100mm.
Theextrudermovesup/downalongZaxis.
Thisoptionisnotavailable,when< Move 10MM >hasbeenselected.
< Temperature > menu
< Prepare > Returnto< Prepare > menu.
< Nozzle >
Adjusttemperatureofnozzlebetweentherangeof0to260°C.
Donotkeepnozzletemperatureat260°Cformorethan10minutes.After10
minutes,decreaseitto230°Candkeepitatthistemperatureforatleast10
minutesbeforeincreasingitagain.Ifyouconsistentlyoperatethe3Dprinter
attemperaturesover230°C,thelifetimeoftheextruderwilldrasticallybe
shortened.
< About > menu
<Version> Checktheversionnumberofthermware.
< Main > menu(duringprinting)
< Info screen > Returnto<Infoscreen>.
< Tune >
Alistofparametersforcontroloftheprintspeed,nozzletemperature,fanspeedand
owrateoflamentduringprinting.
< Pause print > Pauseorinterruptprinting(onlyavailablewhenprintfromSDcard).
<Resumeprint> Continueprintingafterprintinghasbeenpausedorinterrupted.
< Stop print >
Stop printing. The nozzle returns to home position and the build bed moves down.
Nozzlestartscoolingdown(onlyavailablewhenprintfromSDcard).
Stoppingmaytakeseveralseconds.
<Emergencystop>
Terminate any tasks immediately.
Axismovement andextrusionoflamentstops.The3Dprinter doesnotacceptany
inputandthe<Infoscreen>willbenotupdated.Afterwards3Dprinterneedstobe
restarted(fordetailsreferto“f)Restartthe3Dprinter“onpage27).
< Tune > Menu
< Speed >
Adjustprintspeedbetweentherangeof10to300%.Defaultsettingis100%.
Printspeedissetby“Cura“whengeneratingtheGCODE.Thespeedoption
sets a percentage of that speed (e.g. 150%). For best print results, we
recommendtosetthedesiredspeeddirectlyin“Cura“.
< Nozzle > Adjustnozzletemperaturebetweentherangeof0to260°C.Defaultsettingis220°C.