Renkforce RF100 - Page 45

45
Problem Possible Solution
Printingsstopsduringtheprocess.
Disconnect computer from 3D printer while printing from
SD card.
Check the settings of your computer. It must not switch
to standby mode while printing (energy option settings)
or simply shut down (installation of software or software
updatesduringprinting).
Theprintedobjectdoesnotadheretothebuildbed.
Nozzle temperature is too low. Increase nozzle temperature.
Thereareresiduesonthebuildbedthatpreventadhesion
of the object. Clean the build bed (for details refer to
chapter“c)Cleanthebuildbed“onpage42).
Printspeedmaybetoohigh.Reducespeed.
Calibratethebuildbedagain.
Addtherafttotheprintobject.
Theprintedobjectcannotberemovedfromthebuild
bed.
Waituntiltheprintedobjecthascooleddown.
Usethescrapertoremovetheobject.
LC display shows undecipherable content or
remains blank.
Restartthe3Dprinter(refertochapter“f)Restartthe3D
printer“onpage27)
Nozzle cools down unexpectedly. Select < Preheat PLA> to reheat the nozzle and have
furtheractionwithinfollowing5minutesforexampleload/
unloadlament,printingetc.
Movingpathofnozzleisblocked. Always remove any excessive lament on nozzle before
eachprint.
Nozzleisclogged. Cleantheinsideofthenozzle,fordetailsreferto“b)Clean
thenozzle“onpage41.
Extrudertakeswrongdirectionduringprinting. Checkwhetherthelamentspoolmoves smoothlyonits
holder.
Filamentbecomesstuckduringunloading. Loadandunloadlament.