Renkforce RF100

To Previous Page

ThisisapublicationbyConradElectronicSE,Klaus-Conrad-Str.1,D-92240Hirschau(www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in

electronicdataprocessingsystemsrequirethepriorwrittenapprovalbytheeditor.Reprinting,alsoinpart,isprohibited.

Thispublicationrepresentthetechnicalstatusatthetimeofprinting.

1507428_V1_1216_02_LS_m_gb_(2)

Main Page

Default Chapter2
- Table of Contents2
1 Introduction4
2 Explanation of Symbols4
3 Intended Use5
4 Delivery Content5
5 SD Card Content6
- A) 3D Models6
- B) Config6
- C) Manual7
- D) Software7
6 Features and Functions7
7 Working Principle Of The 3D Printer8
8 Safety Instructions9
- A) General Information9
- B) Connecting The Mains10
9 Operating Elements And Parts12
- A) Printer (Front and Back)12
- B) Accessories12
10 Before Installation13
11 Installation13
- A) Set up 3D Printer13
- B) Installation and Connection13
12 Control Panel15
- A) Initial Operation15
- B) Menu Options and Functions15
- C) < Info Screen18
13 General Notes On 3D Printing19
- A) Nozzle Temperature19
- B) Prevent Nozzle Clogging19
- C) Print Layer Thickness20
14 Preparation21
- A) Calibrate Build Bed21
- B) Set Up Filament22
- C) Load Filament23
- D) Change / Replace Filament24
- E) Install "Cura" Software (Optional)24
15 Print from SD Card25
- A) Start Printing25
- B) Pause Printing26
- C) Adjust Parameters During Printing26
- D) Stop Printing26
- E) Perform < Emergency Stop26
16 Print from “Cura“ Software27
- F) Restart The 3D Printer27
- Print from "Cura" Software27
- A) General Notes27
- B) Installation28
- C) Setup of the Software - Windows28
- D) Setup Of The Software - Mac Os32
- E) Software Settings - Windows35
- F) Load Configuration File - Windows38
- G) Load Configuration File - Mac Os38
- H) Load Model File - Windows ® and Mac os39
- I) Start Printing40
- J) Stop Printing41
- K) Perform < Emergency Stop41
17 Cleaning And Maintenance41
- A) Clean The Device41
- B) Clean The Nozzle41
- C) Clean The Build Bed42
- D) Replace Fuse42
- E) Unload Filament43
- F) Store The 3D Printer43
18 Troubleshooting44
19 Disposal46
20 Technical Data46

Renkforce RF100 - Page 47

Table of Contents

Other manuals for Renkforce RF100

Related product manuals