Retsch SM200 - Mounting the Feed Hopper

To Next Page

To Previous Page

Packaging, Transport and Installation

3.8 Mounting the Feed Hopper

WARNING

1.W0004

Risk of injury to skin and hands

Fast rotating cutting blade

– There is a risk of injuring hands, fingers and skin.

• Never operate the device without a feed hopper.

NOTICE

Transport safeguard

– Components may be damaged.

• Operate the machine only without the transport safeguard or

transport the machine only with transport safeguard.

3.8.1 Removing the Transport Safeguard

Fig. 3: Removing the transport aid

• Remove the transport aid (TH).

• Unlock the grinding chamber door, by pulling the mini detent pin (E) upwards

and pressing the handle of the door latch (F) backwards.

• Open the grinding chamber door (T).

• Remove the two locking screws (S).

NOTE

Keep the transport safeguard (TS) for transport at a later date.