Packaging, Transport and Installation
16
Fig. 5: Putting on the protective caps
NOTE
When new, the grinding chamber door and the handle on the door latch are somewhat difficult
to move.
3.9 Installation of the Device
Installation height: maximum 2000 m above sea level
Installation
– Depending on the operating status of the mill, there may be slight
vibrations.
• Place the mill on an even, flat and balanced supporting surface only.
The supporting surface must be stable and must not vibrate.
Installation of the machine
– It must be possible to disconnet the machine from the mains at any time.
• Install the machine such that the connection for the mains cable is
easily accessible.
To Next Page
Loading...