Retsch SM200 - Opening and Closing of the Device; Replacing the rotor

To Next Page

To Previous Page

Operating the Device

5.5 Opening and Closing of the Device

The motor must come to a complete stop before the mill housing can be opened.

• Stop the device by pressing the stop button (G6).

• Pull the mini detent pin (E) upwards

• Press the handle on the door latch (F) backwards.

• Open the grinding chamber door.

NOTE

Do not close the grinding chamber door if the feed hopper is folded out to the side,

because this would damage the device.

Fig. 14: Opening the grinding chamber door

5.6 Mounting the bottom sieve

• Select the appropriate bottom sieve.

• Open the mill housing and push the bottom sieve (I) of your choice into the

device.

5.7 Replacing the rotor

CAUTION

Injuries in the form of cuts

Sharp cutting edges on the rotors and cutting bars

– The sharp cutting edges on the rotors and cutting bars can injure hands.

• Wear protective gloves when replacing the cutting rotors and

cleaning the grinding chamber.

• Use the rotor extraction tool when handling the cutting rotors.