PAGE 7
Basic Operation
Turn the radio ON & OFF
1) Rotate the PWR/VOL knob clockwise till the radio is turned on. The
radio gets started to auto test for two seconds. During auto testing, all
icons will appear on LCD.
2) After auto testing is done, LCD will show channel number and what
functions have been activated by your dealer.
3) Rotate the PWR/VOL knob clockwise to increase its volume or counter
clockwise to reduce its volume.
4) To turn the radio o, rotate the PWR/VOL knob counter clockwise
until the end click�
Monitor
Press the “MON” button on the side of the radio to open the squelch�
This allows you to override the squelch and the CTCSS or DCS tones� It is
useful to monitor the channel before you transmit and ensure there is no
one using the channel when you have CTCSS or DCS tones programmed�
Transmitting
Before transmitting, you can monitor the channel you are using to
ensure it is not busy� Keep pressing “PTT” button and start talking at ap-
proximately 2 inches from the MIC jack� During transmitting, the LED on
the top of the radio will glow red� Release “PTT” button when you have
nished talking�
To Next Page
Loading...
