REXROTH CS351 - Page 22

3 609 929 B45/2013-06 | CS351/CC-CS351 Bosch Rexroth AG 75 /108
Product description
ENGLISH
A slot interface (A)
This interface is intended for use of type A in-
terface modules from Rexroth.
B slot interfaces (B1, B2)
These interfaces are intended for use of type
B interface modules from Rexroth.
Slog B2 is not applicable in compact sys-
tems with integrated computer unit. The com-
puter unit must be configured as interface
module in slot B2 on commissioning.
NOTE
Damage due to improper assembly!
Damage to the connections
 Carefully insert the modules following
the assembly instructions in the mod-
ule operating instructions.
 Only use interface modules from
Rexroth.
An overview of all available inter-
face modules can be found on
the Internet at
www.boschrexroth.com/
schraubtechnik.
NOTE
Damage due to improper assembly!
Damage to the connections
 Carefully insert the modules following
the assembly instructions in the mod-
ule operating instructions.
 Only use interface modules from
Rexroth.
An overview of all available inter-
face modules can be found on
the Internet at
www.boschrexroth.com/
schraubtechnik.
NOTE
Damage due to improper disassem-
bly/assembly!
Damage to the connections
 The computer unit is a permanent part
of the tightening system. It may not be
subsequently installed in or removed
from the Compact System, as is the
case with an interface module.
CS351_zweispaltig - D.book Seite 75 Dienstag, 16. Juli 2013 12:00 12