58
/108
Bosch Rexroth AG CS351/CC-CS351
| 3 609 929 B45/2013-06
General safety instructions
2 General safety
instructions
The Compact System has been manufac-
tured according to the accepted rules of cur-
rent technology. There is, however, still a dan-
ger of personal injury or damage to
equipment if the following general safety in-
structions and the warnings before the steps
contained in these instructions are not com-
plied with.
• Read these instructions completely and
thoroughly before working with the Com-
pact System.
• Keep these instructions in a location
where they are accessible to all users at all
times.
• Always include the operating instructions
when you pass the Compact System on to
third parties.
Intended use
The product described in this documentation
is part of the control and power electronics
for Rexroth tightening systems and is in-
tended for the industrial application of tight-
ening processes exclusively in connection
with further products. Only use the product
with the corresponding connecting cables.
The product is intended for industrial use and
not for private use.
Observe the operating conditions and perfor-
mance limits specified in the technical data.
Intended use includes having read and un-
derstood these instructions, especially chap-
ter 2 “General safety instructions”.
Only use the Compact System CS351 in
conjunction with a Rexroth ErgoSpin/CC-Er-
goSpin hand-held nutrunner or tightening
spindles to tighten and loosen bolts and nuts.
Only use the Compact System CC-CS351 in
conjunction with a Rexroth CC-ErgoSpin
hand-held nutrunner or tightening spindles to
tighten and loosen bolts and nuts.
The integrated logic is not permitted for
safety-relevant applications. Safety-relevant
applications are all applications that may re-
sult in personal injury or property damage.
Improper use
Any use of the Compact System other than
described in section “Intended use” is con-
sidered as improper.
NOTE
The Compact System CS351/CC-
CS351 is not designed to be directly
connected to the public low-voltage
power supply, but is only intended for use
in industrial environments (emission
class A).
CS351_zweispaltig - D.book Seite 58 Dienstag, 16. Juli 2013 12:00 12
To Next Page
Loading...
Need help?
General
