18
User manual RF-KIT Power Amplifier RF2K-S
A VNC connection is password protected.
In the delivery state the VNC password is: „rfkit“
You can change the VNC password at any time:
► Tap the switching area Change Password.
The input field New Password appears:
► Tap into the input field New Password.
A virtual keyboard appears for entering the new password:
► If necessary, tap the switching area show password to make the
entered characters (min. 6 / max. 63 characters) visible.
As long as the minimum number of characters (= 6) for a valid new VNC
password is not reached, the characters entered up to that point are dis
-
played in red.
From the 6th character on, the VNC password is valid and therefore displa-
yed in green.
► Finish the VNC password entry by tapping switching area OK.
The VNC Config screen is then displayed again.
► Tap the switching area Save and apply to save and apply the VNC
settings.
► Tap into the input field/indication area Port.
A virtual keyboard appears for entering the VNC port address:
► Finish entering the VNC port address by tapping the OK switching
area.
The VNC Config screen is then displayed again.
To Next Page
Loading...
