RHOSS KMSR User Manual

41
Section I :: User

Type supervisor : Rhoss Sequencer
Lon factor: No
BMS table: #0
Set the port on the BMS protocol RHOSS, speed 19200, NONE parity
and 2 stop bits.
The serial addresses must be unique and must be assigned
consecutively (1-10) to the individual units sequenced.
For more information on using the on-board display of individual units
refer to the manual H57850 - Electronic controls.
ALARM
!
Prg
MODE
ON
OFF
ALARM
!
Prg
MODE
ON
OFF
The sequencer invitation parameters are displayed in the input/output
status menu, specically:
If the system has been set on OFF from the Sequencer, the chiller
display shows the following screen
 
 Value of the virtual adjustment probe
 System set point
 Unit proportional band calculated by RMST
Enter the Conguration menu BMS.
In I01a mask set:


RHOSS KMSR Specifications

General

Brand	RHOSS
Model	KMSR
Category	Recording Equipment
Language	English