RichAuto A122 - Page 23

Add: 5F
, No.4 building, No 4. Yard, life Rd, life science park,
Tel：010-53275118 Fax
：
direction. To modify
the direction by pressing “
selection list (The
following submenu
b. “4 axis”,
means engraving mode. T
after choosing this submenu.
(2) RoughS
(rough machining value setting)
The “RoughS” is to control the cutting depth ratio of crude knife and fine knife. For
instance, the value 0.7, refers to cutting depth ratio of crude knife(X knife) is 70%, so
the fine knife (Z knife) is 30%.
Modify method
: press“
finish the setting.
(3) Offset (cutter
spacing)
Refers to the spacing distance of
Modify method
: press“
finish the setting.
(4) AtchStrt(attachment
start position)
The start coordinate of the paste wood strip (calculate from the work piece origin), the
value can be achieved from the processing file, its unit is
Modify method
: press“
finish the setting.
(5)
AtchLgth(attached wood strip length)
WorkType
ScwPos
ScwNeg
4 axis
Beijing RichAuto S&T Co., Ltd
, No.4 building, No 4. Yard, life Rd, life science park,
Beiqing St., Changping d
ist.
：
010-53275110/53275111 Web site：
www.richnc.com.cn
the direction by pressing “
”, entering into the direction
following submenu
“ScwPos” and “ScwNeg”
are same argument).
means engraving mode. T
he screen main interface will
change as below
after choosing this submenu.
(rough machining value setting)
The “RoughS” is to control the cutting depth ratio of crude knife and fine knife. For
instance, the value 0.7, refers to cutting depth ratio of crude knife(X knife) is 70%, so
the fine knife (Z knife) is 30%.
: press“
”to input a specific val
ue, and then press“
spacing)
Refers to the spacing distance of
the
two cutters along Y axis direction.
: press“
”to input a specific value, and then press“
start position)
The start coordinate of the paste wood strip (calculate from the work piece origin), the
value can be achieved from the processing file, its unit is
mm.
: press“
”to input a specific value, and then press“
AtchLgth(attached wood strip length)
WorkType
Wrkeg
ScwPos
ScwNeg
WrkPos
WorkType
WZ
0.000 MANU
WY
0.000 F 8
WA
0.000 F SP
Continue
Beijing RichAuto S&T Co., Ltd
ist.
Beijing, China
www.richnc.com.cn
19
”, entering into the direction
are same argument).
change as below
The “RoughS” is to control the cutting depth ratio of crude knife and fine knife. For
instance, the value 0.7, refers to cutting depth ratio of crude knife(X knife) is 70%, so
ue, and then press“
”to
two cutters along Y axis direction.
”to input a specific value, and then press“
”to
The start coordinate of the paste wood strip (calculate from the work piece origin), the
”to input a specific value, and then press“
”to
0.000 MANU
0.000 F 8
0.000 F SP