RichAuto A122 - 3.4 Commissioning of the Machine and Control System

Add: 5F
, No.4 building, No 4. Yard, life Rd, life science park,
Tel：010-53275118 Fax
：
3.4
Commissioning of the Machine and Control System
1）
After turn on the power, users can manually move each axis and confirm the X, Y and
Z axis motors directions. If the movement direction and definition direction are opposite,
users can change the motor phase sequence
2）
According to the original location of the machine coordinates, enter into the
menu--machine setup--
home setup
3） Double-
press “menu” and enter into
stand for input voltage）
, pls c
working
normally(manually trigger, arrow flip )
4) Press”ON/OFF”
button, to check if the controller can control the on/off of the spindle, if
not, pls check the wiring or system configuration.
The machine is in good connection if all the above setting
normal operation.
Beijing RichAuto S&T Co., Ltd
, No.4 building, No 4. Yard, life Rd, life science park,
Beiqing St., Changping d
ist.
：
010-53275110/53275111 Web site：
www.richnc.com.cn
Commissioning of the Machine and Control System
After turn on the power, users can manually move each axis and confirm the X, Y and
Z axis motors directions. If the movement direction and definition direction are opposite,
users can change the motor phase sequence
(A+ ⇄ A- or B+ ⇄ B-).
According to the original location of the machine coordinates, enter into the
home setup
-home direction and reset it.
press “menu” and enter into
manual voltage setup（
the upper
, pls c
heck whether the home switch and tool setting port are
normally(manually trigger, arrow flip )
.
button, to check if the controller can control the on/off of the spindle, if
not, pls check the wiring or system configuration.
The machine is in good connection if all the above setting
has been
Beijing RichAuto S&T Co., Ltd
ist.
Beijing, China
www.richnc.com.cn
17
Commissioning of the Machine and Control System
After turn on the power, users can manually move each axis and confirm the X, Y and
Z axis motors directions. If the movement direction and definition direction are opposite,
According to the original location of the machine coordinates, enter into the
the upper
row of arrows
heck whether the home switch and tool setting port are
button, to check if the controller can control the on/off of the spindle, if
has been
confirmed