RichAuto A122 - 5.4 Automatic processing operation

Add: 5F
, No.4 building, No 4. Yard, life Rd, life science park,
Tel：010-53275118 Fax
：
Press “
”three times, the screen will display
downwards “↓”.
Upper arrows represent input signal
zero, Y zero, Z zero and tool setting gauge.
alarm, hard limit and emergency stop input signal
Manual trigger the corresponding signal switch by pressing “
arrow flip
up indicates that
core cable and so on.
Bottom row represents
output signal
spindle forward on/off
、
inversion output signal.
signal.
Press “
” button can change the arrow direction, so it can control the output of
corresponding port. For example, press “
position of
0, it is equivalent to start the spindle. Press“
downwards, the spindle
stop
 5.4
Automatic processing operation
Auto processing refers to the system runs the file in U disk or in
according to the instruction
must set the machine tool parameters and all of the system parameters correctly.
Auto processing steps:
5.4.1 Set
workpiece origin
Beijing RichAuto S&T Co., Ltd
, No.4 building, No 4. Yard, life Rd, life science park,
Beiqing St., Changping d
ist.
：
010-53275110/53275111 Web site：
www.richnc.com.cn
”three times, the screen will display
two rows of arrows which are
Upper arrows represent input signal
s: the former 4 numbers 0, 1, 2,3
corresponding to X
zero, Y zero, Z zero and tool setting gauge.
Number 4, 5, 6, 7
corresponding to driver
alarm, hard limit and emergency stop input signal
and foot switch.
Manual trigger the corresponding signal switch by pressing “
”,
the corresponding
up indicates that
the signal is normal. If not,
pls check the switch,
output signal
s: the former 4 numbers
0,1,2,3 corresponding to
、
signal to be defined
1, signal to be defined 2, spindle
No.4, 5 corresponding to alarm lamp、
running lamp output
” button can change the arrow direction, so it can control the output of
corresponding port. For example, press “
”to flip the arrow upwards under
0, it is equivalent to start the spindle. Press“
” a
gain, the arrow flip
stop
Automatic processing operation
Auto processing refers to the system runs the file in U disk or in
ner
storage space
according to the instruction
s
, it also called file processing. Before auto processing,
must set the machine tool parameters and all of the system parameters correctly.
workpiece origin
1X 0.000 MAUN
1Y 0.000 F2
1Z 0.000 L SP
Continue
Beijing RichAuto S&T Co., Ltd
ist.
Beijing, China
www.richnc.com.cn
38
two rows of arrows which are
all
corresponding to X
corresponding to driver
the corresponding
pls check the switch,
wiring, 50
0,1,2,3 corresponding to
1, signal to be defined 2, spindle
running lamp output
” button can change the arrow direction, so it can control the output of
”to flip the arrow upwards under
the
gain, the arrow flip
storage space
, it also called file processing. Before auto processing,
user
must set the machine tool parameters and all of the system parameters correctly.