Ricoh 2045e - Page 100

Using the Network Delivery Scanner Function
90
7
B Enter the destination.
Note
r Enter the e-mail address of
the destination when send-
ing via the delivery server.
r It is possible to use letters,
numbers, and periods. The
symbols ()\,;:” cannot be
used.
Reference
For information about how
to enter characters, see Gener-
al Settings Guide.
C Press [OK].
D To enter more destinations, re-
peat steps A to C.
Note
r To deselect a destination,
press [U Prev.] or [T Next] to
display the destination in the
destination field, and then
press the {Clear/Stop} key.
r Pressing the {Check Modes}
key on the control panel lets
you check the list of selected
destinations.
Checking selected destinations
A Use the destination field at the
top of the screen to check
which destinations are select-
ed.
Note
r When multiple destinations
are selected, the selected des-
tinations are displayed in the
order they were selected by
pressing [U Prev.] or [T Next].
r Pressing the {Check Modes}
key on the control panel lets
you check the list of selected
destinations.
G Specify the sender (scan file de-
livery source) if necessary.
To specify a sender, you can select
the sender from the list, enter the
five-digit registration number of
the sender with the number keys,
and search for the sender and se-
lecting it.
Note
r When a sender has been speci-
fied, this information is added
to the scan file. Select a sender
from the senders programed in
the delivery server.
When selecting a sender from the
list
A Press [Attach Sender's Name].
B Select the sender.
The selected sender and its reg-
istration number are displayed.
Note
r When using ScanRouter V2
Professional, [Return Receipt]
is displayed when a sender is
selected.