BRIDGE UNIT INSTALLATION 10 August, 2001
3-34
4. Remove the cover [A] (1 screw).
5. Install the bridge unit [B] (1 shoulder screw, 1 knob screw).
6. Reinstall the front right cover [C].
7. Connect the cable [D] to the main machine.
8. Attach the securing plate [E], as shown.
NOTE: Do not attach it with a screw; this is done when securing the front stand
for the optional finisher.
9. Install the optional finisher (refer to the finisher installation procedure).
B417I102.WMF
B417I103.WMF
[A]
[B]
[D]
[C]
[E]
To Next Page
Loading...
