COPY ADJUSTMENTS: PRINTING/SCANNING 10 August, 2001
6-42
6.8.4 TOUCH SCREEN CALIBRATION
After clearing the memory, or if the touch panel detection function is not working
correctly, follow this procedure to calibrate the touch screen.
NOTE: Do not attempt to use items [2] to [9] on the Self-Diagnostic Menu. These
items are for design use only.
1. Press ", press #$$%, and then press & 5 times to open the Self-
Diagnostics menu.
2. On the touch screen press “Touch Screen Adjust” (or press #).
3. Use a pointed (not sharp!) tool to press the upper left mark .
4. Press the lower right mark after it appears.
5. Touch a few spots on the touch panel to confirm that the marker (
+
) appears
exactly where the screen is touched.
If the
+
mark does not appear where the screen is touched, press Cancel and
repeat from Step 2.
6. When you are finished, press [#] OK on the screen (or press ').
7. Touch [#] Exit on the screen to close the Self-Diagnostic menu and save the
calibration settings.
B027R533.WMF
B027R554.WMF
To Next Page
Loading...
