Ricoh Aficio 1027 - Blank Margin; Main Scan Magnification

10 August, 2001 COPY ADJUSTMENTS: PRINTING/SCANNING
6-37
Replacement
Adjustment
Blank Margin
NOTE: If the leading edge/side-to-side registration cannot be adjusted within the
specifications, adjust the leading/left side edge blank margin.
1. Check the trailing edge and right side edge blank margins, and adjust them
using the following SP modes.
SP mode Specification
Trailing edge SP2-101-
2/3/4
3 ± 2 mm
Right edge SP2-101-6 2 +2.5/-1.5 mm
Leading edge
SP2-101-1
3 ± 2 mm
Left edge
SP2-101-5
2 ± 1.5 mm
Trailing edge (duplex
copy, 2nd side)
SP2-101-7
2 ± 2 mm
Left edge (duplex
copy, 2nd side)
SP2-101-8
2 ± 1.5 mm
Right edge (duplex
copy, 2nd side)
SP2-101-9 2 +2.5/-1.5 mm
A: Trailing Edge Blank Margin
B: Right Edge Blank Margin
C: Leading Edge Blank Margin
D: Left Edge Blank Margin
Main Scan Magnification
1. Print the single-dot grid pattern (SP2-902, no.5).
2. Check the magnification, and adjust the magnification using SP2-909 if
necessary. The specification is ± 1%.
a
`
_
^
B027R509.WMF