10 August, 2001 1,000-SHEET FINISHER INSTALLATION
3-37
2. Install the front joint bracket [A] (2 screws – M4x17) and rear joint bracket [B]
(1 screw – M4x17).
3. Remove the left stand [C] (3 screws)
4. Install the lower grounding plate [D] on the finisher (2 screws – M3x8).
NOTE: Use the screw removed in step 1 and the screw from the accessory
box.
5. Open the front door [E]. Then pull the locking lever [F].
6. Align the finisher on the joint brackets, and lock it in place by pushing the
locking lever.
7. Secure the locking lever (1 knob screw – M3x8) and close the front door.
8. Install the copy tray [G] (1 knob screw – M4x10).
9. Connect the finisher cable [H] to the main machine.
B408I104.WMF
B408I105.WMF
[A]
[B]
[C]
[E]
[F]
[G]
[H]
[D]
To Next Page
Loading...
