Ricoh Aficio 1027 - Page 200

10 August, 2001 SERVICE PROGRAM MODE
4-37
Service
Tables
5
Mode Number/Name Function/[Setting]
Telephone Number
1 Service Telephone Use this to input the telephone number of the service
representative (this is displayed when a service call
condition occurs).
Press the ! key if you need to input a pause (–).
Press the & (Clear/Stop) key to delete the telephone
number.
2 Facsimile Use this to input the fax number which will be printed
on the user counter report.
Press the ! key if you need to input a pause (–).
Press the & (Clear/Stop) key to delete the telephone
number.
3 Consumable Use this to input the telephone number that the
customer uses to order toner (this is displayed in the
inquiry menu of UP mode).
Press the ! key if you need to input a pause (–).
Press the & (Clear/Stop) key to delete the telephone
number.
812*
4 Sales Telephone
Use this to input the telephone number of the sales
representative (this is displayed in the inquiry menu of
UP mode).
Press the ! key if you need to input a pause (–).
Press the & (Clear/Stop) key to delete the telephone
number.
CSS Function816*
This SP is for Japan only. DFU.
[0 = No / 1 = Yes]
CSS-PI Device Code821
This SP is for Japan only. DFU.
[0 = No / 1 = Yes]
NVRAM Data Upload824
Uploads the UP and SP mode data (except for
counters and the serial number) from the NVRAM on
the control board to a flash memory card. (☛ 4.2.8)
While using this SP mode, always keep the front cover
open. This prevents a software module accessing the
NVRAM during the upload.
NVRAM Data Download825
Downloads the content of a flash memory card to the
NVRAM on the control board. (☛ 4.2.8 )
While using this SP mode, always keep the front cover
open. This prevents a software module accessing the
NVRAM during the download.
After executing this SP, switch the copier off and on.
Network Setting
25* Software Switch Sets the reference for the network software.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
26* Network Operation
Mode Setting
Sets the TCP operation mode for the network.
[00000000~FFFFFFFFh / 00000000h / 1 hex unit step]
828*
27*
Network Syslog Server
Address Setting
Sets the syslog server address for the network.
[00000000~FFFFFFFFh / 7F000001h / 1 hex unit step]